In today’s video, I convert my CR-10 with a Bondtech BMG and E3D hotend to a direct drive setup. Direct drive allows for more flexible and exotic materials to be used but comes at the cost of a heavier extruder carriage.
If you are not using a TH3D EZABL and Bondtech with E3D – you will need to find a different carriage.
Prints shown in this video can definitely be improved upon with settings tweaks, just got this to the point where it was working fine.
Carriage by MP23Racing: https://www.thingiverse.com/thing:2789326
Parts required for Upgrade:
Blower Fan: https://amzn.to/2DUMZmN
Stepper Motor: https://amzn.to/2WFE7sq
Cheaper Stepper Motor: http://bit.ly/2Sv0wJC
TH3D EZABL: http://bit.ly/2FzOtQR
Parts and Materials Used:
Fiberlogy PETG: http://bit.ly/2PEki42
Solder Seal: https://amzn.to/2R1txbC
Mini Heat Gun: https://amzn.to/2RwWufT
Heatsink: https://amzn.to/2DhSbBS
Thermal Glue: https://amzn.to/2DhSbBS
TH3D EZABL Set Up: http://bit.ly/2NiQyVJ
TH3D Bootloader Flashing Guide: https://www.youtube.com/watch?v=2SZXXBCVhMk
TH3D EZABL set up video: https://www.youtube.com/watch?v=aUqbRsf7RFs
