Don’t burn your house down – be smart. Keep in mind this method is NOT THE BEST or safest method. There are easier methods, especially ones that have fans, which are linked below. This is just what I do, since I was asked on Twitter, and figured I would share. This is how I was taught to do it at my old job, and have personally preferred it. But be sure to watch the two videos below:
Great alternative way to vapor smooth your parts – watch this especially for larger parts: https://www.youtube.com/watch?v=NiG1jDEG0kA
Dos and Don’ts of vapor smoothing: https://www.youtube.com/watch?v=ZzSGkvdES54
Videos mentioned:
Polysher with Polysmooth: https://www.youtube.com/watch?v=ifukFfCSqU4
Clear Prints with Polysmooth: https://www.youtube.com/watch?v=92C10-n21Po
Clear Prints 2 with Polysmooth: https://www.youtube.com/watch?v=XALChxPG2SY
Designs used:
Skull: https://www.thingiverse.com/thing:441087
Handsome Squidward: https://www.patreon.com/3DPrintGeneral
Pew Pews: The Gatalog
Parts Used (affiliate)
PolyLite ASA: https://amzn.to/2YUDUHp
PolyLite ABS: https://amzn.to/3lilyrn
