Overview

How it was Done

This is the fourth video exploring some of the experimental settings in Cura. This time we explore Draft Shields, Breaking Supports in Chunks, Conical Supports, and Printable Overhangs.

Other Videos
Cura Ironing: https://www.youtube.com/watch?v=CzW45MphcK4
Experimental Settings 1: https://www.youtube.com/watch?v=nLJf343xnqQ
Experimental Settings 2: https://www.youtube.com/watch?v=JK3ur5wCwQI

Download Cura – I had issues with 4.1 stalling during the print, so you may want to download 4.0: https://ultimaker.com/en/products/ultimaker-cura-software

Settings I use for my CR-10 with a Bondtech BMG Direct Drive extruder setup (with Amazon Basics PLA). Your settings will need to be tweaked accordingly: http://bit.ly/2HNoNUY

Amazon Basic PLA (affiliate link): https://amzn.to/2BHPwiW

Designs Used
Support test: https://www.thingiverse.com/thing:2766897
T Support test: https://www.thingiverse.com/thing:3232756
Flower: https://www.thingiverse.com/thing:255980

#3dprinting #cura

Background Music by Joakim Karud http://soundcloud.com/joakimkarud